If you do it right, cleaning a crystal luminaire is quickly done. The effort is as great as with any other luminaire, but the Effect of an occasionally cleaned crystal light is incomparably better.

Before cleaning
. Leave the light fixture hanging and do not disassemble any parts. Do not put the light fixture not be placed in a dishwasher or bathtub, or the electrical Installation will get wet and risk accidents.
Protect the objects under the luminaire or the floor against Moisture, dust and possibly falling parts. A spread out newspaper and a kitchen towel usually suffice. Sensitive surfaces such as Glass tables should be protected by a blanket. The fuse must switched off, and live parts such as sockets and distributors must not get not get wet. Use only a safe ladder. The luminaire must not be be rotated; rather adjust the ladder several times. We advise, wet cleaning in the morning, so that the luminaire is dry by the evening when it is by the evening when it is needed. Do not turn on the fuse until the lamp is completely dry. the lamp is completely dry. For wet cleaning, use only warm water water with dishwashing detergent without citrus additives, i.e. as for cleaning crystal glasses. crystal glasses. If you have hard water, which leaves lime residues, we recommend the use of distilled water. Spirit is not to use.

Cleaning
. A lint-free cleaning cloth of your choice is used for wet cleaning of single large crystals and light bowls, as well as for holding crystal chains during brush cleaning. Disposable cotton gloves have proven to be effective, and can be found can buy in packs of 10 in drugstores.

A brush with soft nylon bristles and a reinforced tip is used for the occasional dusting as well as for wet cleaning of normally difficult to clean to clean light fixture parts (e.g., arms, crystal chains, etc.). When you remove dust from the luminaire by dry brushing from time to time, we recommend a wet cleaning depending on the degree of contamination of the light approximately every six months.

1. First remove loose dust / dirt by dry brushing
. 2. then dip the brush into the cleaning solution, allow to drip off
and carefully brush the areas to be cleaned. For free hanging
Crystal chains, it is necessary to clean them from the other side.
with the free hand (wrapped with the cleaning cloth, or protected by
a cotton glove) support.
3.Dab off any drops that collect with the cleaning cloth; the drying
of the cleaned parts is usually not necessary.
4.Afterwards, still clean light bowls, individual large crystals, etc. with the wet cloth.
5.You can clean small parts by putting on the cotton gloves. put on,
then you touch the small parts and clean them with the the glove.

Or you can use our Crystal Cleaner
Unproblematic and fast.